Installation Diagram for PIC-NIX privacy plate cover for toll highways

The diagram indicates plate height of 3 ft. (x2) for 6 ft. as viewing distance & 6 ft. (head top) viewing height.

 Following the installation instructions will set your PIC-NIX product to eclipse pictures
taken downward from behind at the most common angle
utilized for overhead cameras. 

 Before mounting, you will notice that the PNX turns opaque black for a short time 
(as you tilt it back and forth) The PIC-NIX cover is designed specifically to be effective
in only about 7-8 degrees of visibility. 
This allows the device to be effective yet inconspicuous.
 After mounting the PNX on your vehicle, if you stand 10 to 12 feet behind your vehicle 
(or sit in another car) your plate should appear quite normal. As you walk towards
it the PNX will eclipse the license plate at a certain distance ((depending on your height)
for a short time and then clear again.

 If angled properly the PIC-NIX ppc. will not be noticed by drivers in other vehicles. 
 Your plate will appear as though it has a lightly tinted cover.

WARNING! BEFORE purchasing this product, measure the height of your license plate. We suggest that use of the PNX privacy plate cover will be more successful and stealthy on license plates positioned no lower than 2 feet from the ground. (60cms) Use of a PIC-NIX below this height will make the device more noticeable and potentially unsatisfactory. The higher the PNX + plate is positioned, the less noticeable PIC-NIX becomes.